Drayton digistat scr instruction manual

Digistat RF to the wall (see installation instructions). seconds each time a radio signal is received from the Digistat RF. This will occur approximately every 5 minutes. replacement Digistat RF or SCR is fitted. must arrange for a competent electrician to install it for you. Wiring must conform to the current IEE regulations. is switched off. Digistat RF units are matched correctly to the relevant SCR. This is easily achieved by commissioning each Digistat and SCR in turn. 1. Install (see installation instructions) and turn power on to the SCR (receiver). If a separate programmer is fitted, ensure that it .  · 2. Pull down the battery drawer in the Digistat unit and the screen will go blank. 3. Turn off the power supply to the SCR receiver unit and leave for 5 seconds. 4. Turn the power back on to the SCR unit and check red light is on. 5. with the operation and use of the Drayton Digistat RF range of products. Put the SCR unit into its manual.

Drayton Digistat +3RF Invensys Controls Europe Customer Service Tel: 08Customer Service Fax: 08 Digistat SCR T Certification Mark. The Digistat +3RF thermostat is a programmable thermostat To exit manual mode press once, to return to auto. Digistat RF to the wall (see installation instructions). seconds each time a radio signal is received from the Digistat RF. This will occur approximately every 5 minutes. replacement Digistat RF or SCR is fitted. must arrange for a competent electrician to install it for you. Wiring must conform to the current IEE regulations. is switched off. 2. Pull down the battery drawer in the Digistat unit and the screen will go blank. 3. Turn off the power supply to the SCR receiver unit and leave for 5 seconds. 4. Turn the power back on to the SCR unit and check red light is on. 5. with the operation and use of the Drayton Digistat RF range of products. Put the SCR unit into its manual.

This video shows you an overview of the Drayton Digistat + and +RF. For more information go to www.doorway.ru 22 ຕ.ລ. Take the Digistat RF and hold it within sight of the SCR (no closer than one metre). 6. Remove the battery cover and fit the batteries. 7. The. and/or motorised valve have powered down. to the wall (see installation instructions). approximately every 5 minutes. The green LED on the SCR denotes a.